Poziom 0.00
Ranga: Brak
Beginner Guide - How To Use A Laser Level?
As a beginner, you may not know precisely how to use the best cross line laser level well. So, take a look at this article to know now!
✶✶✶ Picked For You: Best Cross Line Laser Level - Top 10 Laser Level Reviews
Let think about how to use your laser level perfectly
SET UP YOUR LASER LEVEL
That's it! It's effortless to set up and get started. You have to make sure the tripod is a bit. It doesn't have to be perfect as the laser has its leveling mechanism. When the laser spins to balance itself, it starts rotating a laser beam 360 degrees.
This laser beam is red on the RL-5HB, so you get a horizontal, horizontal beam that you can use to measure accurately from there up to +/- 20 arc seconds, 1300 feet, or 400 m from the laser. For me and my line of work to lay a concrete floor, the most significant distance I have to put the layer is usually 100 feet or less from where the laser is set up.
I know that at this 100 'distance, the laser beam is precisely 1/8 of an inch plus and minus on my floor.
USING THE LEVEL LASER FOR LEVEL GROUND
If you are using the laser plane for ground leveling, or you are an excavator and need additional leveling in the foundation, first find a place to place the tripod and laser plane close but far away. You don't want to have to keep moving it while you set your benchmarks.
As you can see in the picture, I am inspecting the subclass in this foundation. I have my scorecard with the numbers on it and move the best laser level for builders up or down until it reads the 360-degree rotating laser beam emitted by the laser.
❈❈❈ Find More Info: the best laser level for builders to buy LaserLevelHub.
Do you understand all of these steps?
HOW TO SAY WHEN GROWTH IS STAGE
The receiver beeps when it reads the laser beam about an inch long. You will hear a quick beep when you need to move the receiver down. It beeps when you need to move the receiver. And there is a solid beep when the receiver is perfectly positioned on the laser beam.
Here is how I use it to check the score. I read the sub-base in what could be shown as a four on my numbering stick. Then I take another one that can be displayed as five and another that can be viewed as 3. I could make ten different measurements on a sub-layer of the floor like this one.
After taking all of these measurements, I averaged them together to get a base average. (it can be 4 or 4.5 or 3.5) it depends on the height of the sub-base at that time. Once I have a GPA, I know whether to skip the highs or fill the lows.
I need to build up the filler layer as I usually lay 4 "thick concrete floors on top of the subfloor and have to place my 4" layer of concrete over the sub-floor. If you are going to use the laser plane to smooth the floor, set your receiver to the best laser level and look for dirt as you pour and spread it.
☞☞☞ See It Here: the best laser level
If you put your bar on the level floor and it beeps firmly, you know you are standing. If it beeps slowly or quickly, you are either too low or too high in that range.